• Post Reply
  • Bookmark Topic Watch Topic
  • New Topic

Passed Part 2/3 - 90%

 
Ravindra Reddy Tummuru
Greenhorn
Posts: 4
  • Mark post as helpful
  • send pies
  • Quote
  • Report post to moderator
Saw the results today morning. Thank you very much for all your feedback/postings.

Site: gb98
Grade: P
Score: 90
Comment: This report shows the total points that could have been awarded in each section and the actual amount of points you were awarded. This information is provided in order to give you feedback on your relative strengths on a section basis. The maximum number of points you could have received is 100, minimum to pass is 70.
Class Diagram (44 maximum) .......................... 43
Component Diagram (44 maximum) ...................... 38
Sequence/Colloboration Diagrams (12 maximum) ........ 9

I believe you would not fail if you digest exam feedback from Passed guys as well as failed ones unless you wanted to reinvent the wheel.

I used to come to this SCEA forum when I confused! about the deliverables but most of the time I gone back with a couple of options (at least) to explore. It's a good learning process and effective utilization of free time.

Wish you best of luck for your future exams.

Cheers,
Ravindra.
 
Anil Vupputuri
Ranch Hand
Posts: 527
  • Mark post as helpful
  • send pies
  • Quote
  • Report post to moderator
Hi Ravindra Reddy,

Thats a good score..Congratulations..

Cud u pls answer following qstns,

1) Did u change BDOM (like Association, Multiplicity or anything)
2) If you didn't change the BDOM then how did you handle lay-over case.
3) Which tool did u use for your drawings and how detail ur class-diagram (like including methods & attributes)
4) How much time did u spend.

Thanks.
 
H. Hafer
Ranch Hand
Posts: 108
  • Mark post as helpful
  • send pies
  • Quote
  • Report post to moderator
Congrats Ravindra!

Harbo
 
sanjeevmehra mehra
Ranch Hand
Posts: 75
  • Mark post as helpful
  • send pies
  • Quote
  • Report post to moderator
Congrats : ) !!!


Pls. pass tips for Part I & Part II.


Thanks & Regards,
Sanjeev.
 
Ravindra Reddy Tummuru
Greenhorn
Posts: 4
  • Mark post as helpful
  • send pies
  • Quote
  • Report post to moderator
Hi Anil,

1) Did u change BDOM (like Association, Multiplicity or anything)
A) I did not change BDOM but extended where ever possible & feasible. I too provided as much information as i can regarding Dependency,Association, Multiplicity, etc.

2) If you didn't change the BDOM then how did you handle lay-over case.
Let me check!
3) Which tool did u use for your drawings and how detail ur class-diagram (like including methods & attributes)
A) I used Rational Rose (Trial Version) with RoseGraph. My main objective was to provide Specification level diagram and simple & easy to understand. Hence no definition of methos and attributes.

4) How much time did u spend.
A) I have not made any note for this as i was enjoying rading concepts on web & books but i guess it was around 75-85 hours.
 
  • Post Reply
  • Bookmark Topic Watch Topic
  • New Topic