• Post Reply
  • Bookmark Topic Watch Topic
  • New Topic

suncertify.properties

 
Theo van Loon
Ranch Hand
Posts: 71
  • Mark post as helpful
  • send pies
  • Quote
  • Report post to moderator
Hello all,
can some of you help me out on this one. It's about the following passage in the assignment given by Sun:
Your programs must not require use of command line arguments other than the single mode flag, which must be supported. Your program must not require use of command line property specifications. All configuration must be done via a GUI, and must be persistent between runs of the program. Such configuration information must be stored in a file called suncertify.properties which must be located in the current working directory.
How are you all handling this? I didn't see many posts on this subject...
 
Satish Avadhanam
Ranch Hand
Posts: 697
  • Mark post as helpful
  • send pies
  • Quote
  • Report post to moderator
Hi Theo, here are a couple of links that I think should help.
suncertify.properties data
how do I have to make "property file"?
suncertify. properties
I did'nt read all of them, but took a glance and thought might be helpful. Good Luck
 
George Marinkovich
Ranch Hand
Posts: 619
  • Mark post as helpful
  • send pies
  • Quote
  • Report post to moderator
Hi Theo,
There's actually quite a few threads on the suncertify.properites file.
Here's one Topic: NX: Mode Flag Confusion
As you can see, the name of the thread doesn't always convey all the things discussed in the thread. That's not necessarily the fault of the thread originator, often the discussion moves into new areas after the thread has been created.
My advice is to use the search function (located at the top of the SCJD page): search
Try looking for: suncertify.properties
 
  • Post Reply
  • Bookmark Topic Watch Topic
  • New Topic